
Special Coatings and Waterproofing in Saskatoon and Across Saskatchewan
MAGNUS applies protective coatings and waterproof membranes on foundations, parkades, decks, tanks and concrete surfaces across Saskatchewan. Getting water out of a structure protects the structure itself, not just the finish on top of it.
We measure before we quote.
Mon–Fri, 8am–5pm
- Award-Winning Contractor
- Licensed & Insured
- 7,000+ Projects Completed
- Free Consultation
- Financing Available
- Serving Saskatoon & Surroundings Since 2008
What our customers say
At a glance
A coating is only as good as the surface underneath it. Most failures come from preparation rather than product, because a membrane cannot bond to concrete that is dusty, damp or still curing. MAGNUS prepares the substrate before applying anything.
Free
Consultation to talk your job through
Photos
Send photos and a specialist will reach out
Financing
Available, ask at your consultation
Since 2008
Insulating and repairing Saskatchewan buildings
Service area: Available in Saskatoon and within 50 km of the city, including Warman, Martensville and Delisle.
Signs you need special coatings & waterproofing
Hydrostatic pressure is pushing moisture through the concrete itself.
Minerals left behind as water passes through and evaporates at the surface.
The surface was not prepared properly before the previous application.
Water and salt have reached the reinforcement and it is expanding as it corrodes.
The waterproof layer has failed or was never properly detailed at the edges.
Freeze and thaw cycling is opening the crack a little further each winter.
Have concrete or a foundation in Saskatchewan taking on water? A site assessment is the place to start. Call (306) 880-2878 · Mon–Fri, 8am–5pm
How long it takes
| Foundation section | Two to four daysExcluding any excavation |
|---|---|
| Parkade or deck area | One to three weeksDriven by area and prep |
| Crack repair | One to two daysDepends on length and access |
Timeframes are typical for a straightforward job and are confirmed at the consultation.
How we handle special coatings & waterproofing
Assess the substrate
We check the concrete condition, moisture content and any active water entry before recommending a system.
Prepare the surface
Grinding, cleaning and crack repair, since adhesion depends almost entirely on how well this step is done.
Apply the system
Membrane or coating applied to the specified thickness, with edges, joints and penetrations detailed properly.
Cure and verify
Conditions are controlled during curing and coverage is checked before the area is returned to use.
Ready to sort out your special coatings & waterproofing?
Serving Saskatoon. The consultation is free and there is no obligation.
What it costs
Preparation usually costs more than the coating. Price follows area, substrate condition, how much repair is needed first, and the system specified for the exposure. Excavation, where a foundation must be reached from outside, is the largest variable.
| Substrate condition | Damaged concrete must be repaired before coating |
|---|---|
| Area to be treated | The main driver once preparation is known |
| System specified | Exposure and traffic determine the product |
| Excavation required | Exterior foundation access is the largest single cost |
| Access and containment | Occupied buildings need protection and ventilation |
We do not publish fixed prices, because the number depends on what the consultation finds.
What you get with MAGNUS
Preparation first
Adhesion depends on the substrate, so that is where the work goes.
Water traced
We identify where water enters before choosing a system.
Licensed and insured
Business licence on file and full liability coverage.
Free consultation
Talk it through with us at no cost before anything is quoted.
Local and seasonal factors in Saskatoon
Freeze and thaw cycling is hard on Saskatchewan concrete. Water enters a crack, freezes, expands and widens it, then repeats the cycle the following day.
Road salt tracked into parkades accelerates the same process by attacking the reinforcement inside the slab. Sealing the surface early is considerably cheaper than structural repair later.
Common Questions
Why do concrete coatings fail?
Almost always because of preparation rather than product. A coating cannot bond to concrete that is dusty, oily, damp or still curing. Grinding, cleaning and repairing cracks first is what determines whether the system lasts. Moisture testing of the slab before application is a step worth insisting on for any large area.
Should a foundation be waterproofed inside or outside?
Outside is more effective, because it stops water before it enters the concrete, but it requires excavation and costs considerably more. Interior systems manage water that has already entered and are the practical choice on many existing buildings.
What causes concrete to spall in a parkade?
Water carrying road salt reaches the steel reinforcement inside the slab. The steel corrodes and expands as it does, which pushes the concrete off from the inside. Sealing the surface prevents the water and salt reaching the steel.
Frequently asked questions
Most systems need a dry, cured substrate to bond properly. If the concrete is damp because water is actively entering, that has to be dealt with first. Applying over an active leak is how coatings end up peeling.
It depends on the system, the exposure and the traffic over it. A protected foundation membrane lasts far longer than a trafficked parkade deck. We will give a realistic expectation for your situation at the assessment. Maintenance matters too, since a coating inspected and touched up periodically outlasts one left alone until it fails.
Often yes, with the work zoned so sections are done in sequence. Ventilation during application and curing is the main constraint, and we plan that around occupancy before the crew mobilises. Odour during application is the other consideration, and we will tell you what to expect before the work starts.
Yes, and it is part of the scope rather than an extra. A coating spanning an unrepaired moving crack will split along that line, so the repair is what makes the coating worth applying. Moving cracks need a flexible detail rather than a rigid filler, and identifying which is which is part of the assessment.
Yes. Interior systems are common on existing buildings where excavating the outside is impractical or too costly. We will explain the trade-offs against exterior work honestly before you decide. Where water is under pressure, drainage and a sump may be needed alongside the coating rather than instead of it.
Related services
Flat Roof Applications & Restoration
Flat roof systems, coatings and restoration that extend service life without a full tear-off.
Flat Roof Applications & Restoration detailsEfficient Foundations
Insulating foundations, slabs and rim joists so heat stops leaving through the bottom of the building.
Efficient Foundations detailsCommercial Spray Foam
Large-scale spray foam for warehouses, shops, agricultural buildings and cold storage.
Commercial Spray Foam detailsSee the full range on our Saskatoon insulation and building envelope services page, or book a free consultation.
Industry leaders in comfortable, healthy & efficient buildings
Get special coatings & waterproofing priced properly
We offer full consultations. With 7,000+ projects completed, we have seen it all and can often diagnose from photos. Send us photos and a specialist will reach out. If an on-site consultation is needed, they will let you know. Mon–Fri, 8am–5pm.