
Basement and Garage Finishing in Saskatoon, From Insulation to Finished Wall
MAGNUS finishes basements, garages and shops across Saskatoon, handling insulation, vapour barrier, drywall, taping and texture with one crew. Getting the moisture detail right below grade is what decides whether the finished space lasts.
We measure before we quote.
Mon–Fri, 8am–5pm
- Award-Winning Contractor
- Licensed & Insured
- 7,000+ Projects Completed
- Free Consultation
- Financing Available
- Serving Saskatoon & Surroundings Since 2008
What our customers say
At a glance
Below grade, the moisture detail matters more than the insulation depth. Concrete holds and releases water, and a wall built tight against it without the right assembly traps that moisture inside the framing. MAGNUS specifies the assembly before framing starts, since it cannot be corrected afterward.
Free
Consultation to talk your job through
Photos
Send photos and a specialist will reach out
Financing
Available, ask at your consultation
Since 2008
Insulating and repairing Saskatchewan buildings
Service area: Available in Saskatoon and within 50 km of the city, including Warman, Martensville and Delisle.
Signs you need basement & garage finishing
Bare concrete and open joists, ready for a full envelope and finish.
Uninsulated walls and ceiling mean heat leaves as fast as it is made.
Moisture is trapped in the assembly, often behind an incorrect vapour layer.
The slab is uninsulated and pulling heat out of the room continuously.
Water is moving through the concrete and needs managing before framing.
Steel or bare frame construction needs sealing as well as insulating.
Planning a basement or garage build-out in Saskatoon? We can scope the whole envelope and finish in one quote. Call (306) 880-2878 · Mon–Fri, 8am–5pm
How long it takes
| Garage insulation | One to two daysInsulation and board |
|---|---|
| Basement envelope | Two to four daysInsulation and vapour barrier |
| Full basement finish | One to three weeksDepends on size and scope |
Timeframes are typical for a straightforward job and are confirmed at the consultation.
How we handle basement & garage finishing
Check for moisture
We look for water entry, damp concrete and white chalky residue first, because framing over an active moisture problem invites failure.
Specify the assembly
Insulation type, position and vapour control are decided together, since below grade they only work as a set.
Insulate and seal
Rim joists sealed, walls insulated to spec, vapour barrier run continuous and sealed at every penetration.
Board and finish
Drywall installed, taped, textured and left ready for paint, or painted if that was included in the scope.
Ready to sort out your basement & garage finishing?
Serving Saskatoon. The consultation is free and there is no obligation.
What it costs
Cost follows square footage, the assembly specified and how much finishing is included. An insulated and boarded garage is a straightforward job. A full basement development with multiple rooms is a larger project and gets a detailed written scope.
| Square footage | The main driver on any development |
|---|---|
| Assembly specified | Spray foam against framed walls with batts |
| Moisture correction | Any water issue must be resolved before framing |
| Finish level | Ready for paint, or textured and painted |
| Layout complexity | More rooms means more corners, doors and detailing |
We do not publish fixed prices, because the number depends on what the consultation finds.
What you get with MAGNUS
Moisture handled first
Below-grade water addressed before any framing goes up.
One crew throughout
Insulation, barrier, board and finish from the same company.
Licensed and insured
Business licence on file and full liability coverage.
Free consultation
Talk it through with us at no cost before anything is quoted.
Financing available
Ask at the consultation if you would like to spread the cost.
Local and seasonal factors in Saskatoon
Saskatoon basements sit in soil that freezes deep and thaws hard, so foundation walls move more than they do in milder climates. That movement is one reason below-grade moisture shows up years after a house was built.
Spray foam directly against concrete handles it well, because it seals the wall and controls vapour in a single layer with nothing behind it to trap water.
Common Questions
What is the best way to insulate a basement in Saskatchewan?
Closed-cell spray foam applied directly to the concrete is the most reliable approach, because it insulates and controls vapour in one layer with no gap behind it. Framed walls with batts work too, but the vapour detail has to be exactly right.
Do I need a permit to develop a basement in Saskatoon?
Yes, basement developments generally require a building permit, and adding a bedroom brings egress window requirements with it. Confirm current requirements with the City of Saskatoon before starting, since rules and fees change. Egress rules in particular catch people out, since a window that looks large enough often is not once measured.
Should I insulate my garage if it is not heated?
It still helps if the garage is attached, because it reduces heat loss from the house through the shared wall and the room above. For a detached garage, insulation only pays off if you intend to heat the space.
Frequently asked questions
Not until the water problem is solved. Framing and drywall over an active leak traps moisture and creates a mould problem inside a wall you cannot see. We will identify it at the consultation and say what needs doing first.
Both are available. Some clients want the envelope done and will handle the rest themselves. Others want it taken through to a finished, painted room. Tell us which at the consultation and we will scope it accordingly. Splitting it that way can also spread the cost across two seasons if that suits your budget better.
Yes, financing is available. Ask about it at the consultation and we will go through the options with you before you commit to anything. It suits a larger development where the monthly cost can be weighed against the value the finished space adds. We will set out the options plainly, with no pressure to take one.
Warmer than an uninsulated one, but it will still drop below freezing in a Saskatoon winter without a heat source. Insulation slows heat loss, it does not create heat. If you want it above freezing, plan for heating.
We can advise on what is required and provide the documentation you need. The permit is taken out in the homeowner's name in most cases, and we will walk you through the process at the consultation. Building on a permit matters at resale too, since unpermitted development can complicate a sale years later.
Related services
Fiberglass & Mineral Wool Insulation
Batt insulation and vapour barrier installed to spec, in new builds, renovations and basement developments.
Fiberglass & Mineral Wool Insulation detailsSpray Foam Insulation
Closed-cell spray polyurethane foam (SPF) that insulates and seals in one pass, applied by certified applicators.
Spray Foam Insulation detailsDrywall Services & Repair
Boarding, taping, texture and repair, finished ready for paint by the crew that started the job.
Drywall Services & Repair detailsSee the full range on our Saskatoon insulation and building envelope services page, or book a free consultation.
Industry leaders in comfortable, healthy & efficient buildings
Get basement & garage finishing priced properly
We offer full consultations. With 7,000+ projects completed, we have seen it all and can often diagnose from photos. Send us photos and a specialist will reach out. If an on-site consultation is needed, they will let you know. Mon–Fri, 8am–5pm.